Home > News > Content
Common Problems And Treatment Methods Of Garden Machinery And Equipment - Oil Saw.
- Apr 20, 2018 -

The mechanical equipment of the garden includes many kinds, such as: oil saw, hedgerow machine, mower, ground drill and so on. In these garden machinery equipment, oil saw.

Is the most commonly used mechanical equipment, in the process of using the oil saw, always due to the objective factor or the human factor influence, the oil saw.

There are often some failures, which are manifested in the following:

The engine is not easy to start.

Engine starting difficulty, more with steam, oil, electricity. To find the cause of the problem, consider these three aspects:

First of all, it is necessary to consider whether the spark discharge effect of spark plugs is not ideal. If this is the case, the space of spark plug should be adjusted.

Or a new spark plug;

Secondly, it is necessary to consider whether the ignition caused by the magneto is not correct. If it is the reason for this, the engine should be re-adjusted.

Finally, consider whether it is due to the use of substandard gasoline, or the lack of pure gasoline to cause engine trouble, etc.

If this is the case, then change the gasoline.

In addition, it is also necessary to consider whether it is due to the blockage of the air filter, which causes the air intake to be difficult, if so, to air.

The filter is cleaned.

Two, do not value oil saw maintenance.

1. The oil tank is well sealed, and the mixture ratio is reasonable. Fuel mix ratio: 25:1 (93#) standard gasoline 25: beautiful.

Fu 2 stroke engine oil 1)

2. Check the air filter, spark plug, carburetor, guide plate and other parts every month to ensure the failure.

3. The machine core and the combustion chamber shall be cleaned every six months, and the parts shall be repaired once a month to ensure the normal state.

4. Check the hunger: check every time before use, ensure the line is in good condition, have normal power, normal load, and no aging of high pressure coil.

5. Fuselage maintenance: the surface of the fuselage should be glossy without mechanical damage and rust should be removed and painted.

6. Chain: if the oil saw is not used for a long time, clean the chain with a brush and put it in the oil pool for safekeeping.


Related Products