Home > News > Content
Requirements For The Use Of Oil Saw Oil
- Apr 20, 2018 -

Now the utilization rate of the oil saw in garden machinery is higher and higher, we all know that the work of the oil saw can not do without oil, it needs to use engine oil, steam.

Oil and oil saw chain lubricating oil, etc. But not all oil can be used, in order to better use oil saw, must use oil.

First, engine oil.

The motor oil of the oil saw can only use the high quality two-stroke engine oil, to ensure the engine has a long service life, do not use the ordinary four.

Engine. When using other two stroke engine oil, its model should reach tc quality. Poor quality gasoline or oil can cause damage.

Machine, seal ring, oil duct and fuel tank.

Second, the gasoline

Gasoline can only use unleaded gasoline above 90. When adding gasoline, the tank cover and the refueling mouth must be cleaned before refueling to avoid any debris.

Into the tank. The high branch saw should be placed in a flat place to cover the tank top. Don't let the gasoline spill out when you come on, you can't fill the tank too full. add

Use your hand to tighten the cap after oil.

The mixture ratio of gasoline and oil.

The mixture ratio of gasoline and oil: the two stroke engine oil used for the high branch saw engine is 1:50, i.e., 1 portion of oil and 50 portions of gasoline; make

Use other engines that meet the tc level of 1:25, or 1 portion of engine oil and 25 portions of gasoline. The hybrid method is in a fuel tank that allows fuel to be loaded.

Pour in the oil, then pour in the gasoline and mix well. The gasoline engine oil mixture will age, and the general configuration should not exceed one month.

The dosage. Special attention should be paid to avoiding direct contact between gasoline and skin, and to avoid gasoline-derived gases.


Related Products